Cuboo Induction Heater Pro V2

Cuboo Induction Heater Pro V2
The improved induction heater comes with a display, new electronics, adjustable timer, adjustable heating range and replaceable inner glass section. A lot of experimentation has gone on behind the scenes and we are confident that the new heater will be able to meet even the toughest requirements.

The new Cuboo Heater can be operated with two exchangeable 18650 Li-Io batteries, which is sustainable and ensures a long lifespan.

The improved Cuboo Pro V2 heater impresses with great features.

Power mode setting 30-60 watts
USB C charging port
Adjustable timer 10-60 seconds
Session Counter
The display goes out after 3 minutes
The heater switches off after 10 minutes
2 x 18650 rechargeable batteries replaceable (not included)
Strong magnet hidden under the housing surface
Aluminum housing and buttons
OLED Display
Diameter of the chamber: 13mm
Height of the heating area is adjustable and with the shorter screw, which is separately in the packaging, the area can be made even larger.
The screw is now ceramic!
The glass on our model is replaceable and available as a spare part
Press 3 times to switch on/off
Press 2 x to set the timer
German operating instructions (English as download)
The power mode
In power mode, you can set the heat output from 30 to 60 watts (70 watts in boost mode). You should always make sure that your Dynavap clicks. The timer starts immediately after inserting the Dynavap. After 10-60 seconds (depending on the setting) the heater stops heating for safety reasons and shows Time out on the display. The display is only unlocked by pressing the small button.

The display
In the display you can see the wattage as well as the timer and the battery status

The performance
The Cuboo Induction Heater Pro V2 is powered by two 18650 Li-Io batteries. This means that the batteries are not permanently installed and can be changed at any time or charged with an external charger. Of course, you can also charge the batteries in the device via the USB-C port. Here, the charging current is limited to one ampere per cell (5V 2A).

We recommend a USB 3.0 Quickcharger. The batteries last approx. 30 clicks or heating processes (this depends on e.g. outside temperature, temperature of the cap and the vape, type of cap, length of heating process, settings etc.). If the capacity of the batteries dwindles, the display may show lower wattages than those set, as the maximum power is no longer available.

Size and weight:

Weight: 277 grams
Dimensions: 11 x 6.3 x 2.3 cm
Scope of delivery:
1 x Cuboo Induktionsheizer Pro V2 (black)
1 x USB C charging cable
1 x Replacement screw to adjust the heating chamber height even further (exclusive to us)
1 x Metal rod to conveniently adjust the screw (exclusively only available from us)
1 x instruction manual in German
Our conclusion:
The Cuboo Heater Pro V2 induction heater has been sensibly improved in many areas and guarantees gentle inhalation without burning or roasting aromas. The feel and look are very appealing and the heater has a high-quality feel. Our clear recommendation to buy.

Attention: Batteries are not included and must be purchased separately. We recommend using Molicel because of the boost mode.

Please note: The Cuboo Heater Pro V2 does NOT work with the Dani Fusion and also NOT with the new Tempest from Mad Heaters due to insufficient power! We are working on a solution for these two devices. However, you can use the Wand, which works with all DynaVap-like devices.